Standing Seam Roof Mounting
SataMount RCT secures compatible satellite mounting hardware to raised standing seams without drilling through the roof panels.
Clamp-on system • SataMount RCT
Mount to the seam, not through the panel.
Standing seam roofs need an attachment approach that accounts for the roof profile and panel movement. SataMount RCT uses four RoofClamp RCT clamps with stainless-steel set screws to secure two structural channels to compatible raised seams.
- No roof-panel penetration for compatible seams
- Two 27-inch P1000T Defender-finish Unistrut channels
- Designed for installation with standard hand tools
- Individual seam compatibility must be verified
Included components
| Mounting channels | 2 × 27-inch, 12-gauge P1000T Defender-finish Unistrut |
|---|---|
| Seam attachments | 4 × RoofClamp RCT clamps with set screws |
| Channel nuts | 4 × ¼-20 Defender Series |
| Mounting bolts | 4 × ¼-20 × 1½-inch 304 stainless steel |
|---|---|
| Flat washers | 4 × ¼-inch 304 stainless steel |
| End caps | 4 × vinyl channel end caps |
Component specifications are based on the existing SataMount site. Verify the current kit documentation before installation.
RCT components and seam profile examples
Review the RCT kit components and representative standing-seam profiles. These illustrations are a visual reference, not a guarantee that any particular seam or roof system is compatible.
Illustrations are reference materials. Verify panel geometry, compatible attachments, fasteners, roof structure, and loads before installation.
Customer installation example
Starlink® Pivot Mount with SataMount RCT
This customer photograph shows a Starlink dish and Pivot Mount supported by SataMount RCT rails on a standing seam metal roof.
The pictured configuration is an installation example, not a universal compatibility or load-rating claim. Confirm equipment-specific mounting requirements, seam compatibility, snow and wind loads, and applicable manufacturer instructions.
Review compatibility FAQs